I was so proud of my creation until I shot them. Well they shot well, but when I pulled them out of the target some of the points stayed in the target.
Probably my fault, but anyway.
I made up some cedar arrows and glued the field tips on with Ferr-L-Tite. I didn't clean them with alcohol or acetone first. Could there be any other reason why they pull off?
The target is a new 3D target my sweet wife bought at the banquet and it's HARD to pull those arrows out. I could use some suggestions on that too, if anyone knows. Is there some lubricant to put on them. They came pre-finished from 3rivers.
Points not sticking
Threaded Mode