08-08-2011, 08:58 AM
|
#4
|
Senior Member
Join Date: Jan 2008
LSBA Region: 78
Location: Georgetown,Tx.
Posts: 179
Points: 1170.00
|
Quote:
Originally Posted by RickBarbee
Got to clean the film of oil from inside the points before ya glue them on.
Sometimes the heat will burn the oil away enough to get a good bond, but a lot of the time it won't, so it's best to clean it away with acetone or similar.
Get a bar of cheap soap, and scrub it on to the point, and about 2" up the shaft before shooting into the 3D. They'll pull a lot easier that way.
Rick
|
This^^^
Bisch
|
|
|